Super-micro-computer AOC-USAS-S4I Manual do Utilizador descarregar pdf (Página 13)

3-1

Safety Information and Technical Specications

Chapter 3

Boot Controller and Bootable Array

To section describes the steps required establish a boot controller and a bootable

array. If you are creating establishing the boot controller and array on an existing

OS, skip to: Installing the Driver on an Existing Operating System.

3-1 Boot Controller Setup

To set the system to boot for a disk drive or controller array:

1. Enter system setup and navigate to the drive boot sequence.

2 Using the arrows provided or grab and drop, move boot controller to the rst

item on the list.

If your systems supports only one boot controller, go to the next section.

For more information, refer to your computer’s documentation.

3-2 Creating an Array

This example uses a RAID 1 array (minimum of two hard drives).

You can establish an array with a different RAID level or change the array level

later.

You can create an array using either tool: Array Conguration Utility with keyboard

navigation and menu interface (BIOS) or Adaptec Storage Manager.

Warning: Do not mix SAS and SATA drives in the same array. The Adaptec

Storage Manager generates a warning if you try to create a logical drive using a

combination of SAS and SATA disk drives.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Sem comentários

Super-micro-computer AOC-USAS-S4I Manual do Utilizador Página 13