Super-micro-computer SUPER X8STE Manual do Utilizador descarregar pdf (Página 29)

Chapter 2: Installation

2-5

1. Unplug the power cord from the

power supply.

2. Using a screwdriver, loosen and

remove the heatsink screws from

the motherboard in the sequence

as shown in the picture on the

right.

3. Hold the heatsink as shown and

gently loosen it from the CPU by

moving it from side to side. (Do

not use excessive force)

4. Once it is loosened, remove the

heatsink from the CPU socket.

5. To reinstall the CPU and the

heatsink, clean the surface of

the CPU and the heatsink to

remove the old thermal grease.

Reapply the proper amount of

thermal grease on the surface

before reinstalling them on the

motherboard.

Using a screwdriver to

Remove Screw#1

Remove Screw#2

Passive Heatsink Removal

4. Finish the installation by fully

tightening all four screws. Do not

over-tighten to avoid possible

damage to the CPU.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 104 105

Sem comentários

Super-micro-computer SUPER X8STE Manual do Utilizador Página 29