SUPER MICRO Computer SUPERSERVER 6012P-6 Manual do Utilizador descarregar pdf (Página 41)

Chapter 5: Advanced Motherboard Setup

5-5

5-3 Connecting Cables

Now that the processors are installed, the next step is to connect the

cables to the board. These include the data (ribbon) cables for the periph-

erals and control panel and the power cables.

Connecting Data Cables

The ribbon cables used to transfer data from the peripheral devices have

been carefully routed in preconfigured systems to prevent them from block-

ing the flow of cooling air that moves through the system from front to back.

If you need to disconnect any of these cables, you should take care to keep

them routed as they were originally after reconnecting them (make sure the

red wires connect to the pin 1 locations). If you are configuring the sys-

tem, keep the airflow in mind when routing the cables. The following data

cables (with their motherboard connector locations noted) should be con-

nected. See the motherboard layout figure in this chapter for connector

locations.

! IDE Device Cables (J2A and J3A)

! Floppy Drive Cable (JP7)

! Ultra 160 LVD SCSI Cables (JA1 and JA2)

! Control Panel Cable (JF2, see next page)

Connecting Power Cables

The P4DPR-6GM+ has a 20-pin primary power supply connector designated

"ATX Power" for connection to the ATX power supply. Connect the

appropriate connector from the power supply to the "ATX Power"

connector to supply power to the motherboard. See the Connector

Definitions section in this chapter for power connector pin definitions.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 109 110

Sem comentários

SUPER MICRO Computer SUPERSERVER 6012P-6 Manual do Utilizador Página 41